Iron-on transfer instructions

A test image is included with your iron-on transfer; use this on a scrap of fabric to practice the application.

Here is how to do it with an iron:

1. The iron-on transfer adheres best to cotton clothing with the lowest possible synthetic content. Iron the fabric smooth beforehand.
2. Preheat your iron to 140 degrees and turn off the steam. Use a hard surface, e.g., a wooden board.
3. Place your iron-on transfer with the white side facing down on the desired spot and cover it with parchment paper.
4. Press the iron firmly onto the covered transfer for 15-20 seconds.
5. Wait until your transfer has cooled down and carefully peel off the film, keeping it flat against the fabric. If the film does not peel off yet, press again.
6. Place parchment paper over the image and press again with the iron for approx. 5 seconds.

Ta-da! Finished.

Here are the settings for your press:

1. Temperature: 130 - 140 degrees
   
2. Pressing time: 12 - 15 seconds
3. Pressure: medium pressure (approx. 3 bar)